|
|
 |
|
|
Digital cable by grehh hernjer
|
|
|
Digital cable |
|
|
|
|
|
Business,Business News,Business Opportunities
|
|
In 1989, General Instrument (which was later acquired by Motorola) demonstrated that it was possible to convert an analog cable signal to digital and transmit it in a standard 6-MHz television channel. In the 1990s cable providers began to invest heavily in new digital based distribution systems. Increased competition and programming choices from Direct-broadcast satellite services such as DirecTV, Dish Network, and PrimeStar caused cable providers to seek new ways to provide more progamming. Customers were increasingly interested in more channels, pay-per-view programming, digital music services, and high speed internet services. By 2000, most cable providers in the US were offering some form of digital services to their customers.
Digital cable technology has allowed cable providers to compress video channels so that they take up less frequency space and to offer various two-way communication capabilities. This has enabled digital cable providers to offer more channels, video on demand services (without use of a telephone line), telephone services, high speed internet services, and interactive television services. In addition, digital cable technology allows for error correction to ensure the quality of the received signal and uses a secure digital distribution system (i.e. a secure encrypted signal to prevent eavesdropping and "stealing" service).
Most digital cable providers use QAM for video services and DOCSIS standards for data services. Some providers have also begun to roll out video services using IPTV or Switched video technologies.
Digital cable technology can allow many tv channels to occupy the frequency space that would normally be occupied by a single analog cable tv channel. The number of channels placed on a single analog frequency depends on the compression used. Many cable providers are able to fit about 10 digital SD channels or 2 digital HD channels on a single analog channel frequency. Some providers are able to squeeze more channels onto a single frequency with higher compression, but often this can cause the video quality of the channel to degrade.
The addition of this capability complicates the notion of a "channel" in digital cable (as well as in over-the-air ATSC digital broadcasts). The formal names for the two numbers that now identify a channel are the physical channel and the subchannel.
The physical channel is a number corresponding to a specific 6MHz frequency range. See: North American cable television frequencies.
The subchannel is a logical channel of data within the physical channel. Technically there can be up to 1024 subchannels in a physical channel, though in practice only a few are used (since the bandwidth must be divided among all the subchannels).
There are two ways providers try to make this easier for consumers. The first, accomplished through PSIP, is where program and channel information is broadcast along with the video, allowing the consumer's decoder (set-top box or display) to automatically identify the many channels and subchannels.
The second (also accomplished through PSIP) is where, in an effort to hide subchannels entirely, many cable companies map virtual channel numbers to underlying physical and sub-channels. For example, a cable company might call channel 5-1 "channel 732" and channel 5-2 "channel 733". This also allows the cable company to change the frequency of a channel without changing what the customer sees as a channel number. In such arrangements, the physical/sub-channel numbers are called the "QAM channel", and the alternative channel designation is called the "mapped channel", "virtual channel", or simply "channel".
In theory, a set-top box can decode the PSIP information from every channel it receives and use that information to build the mapping between QAM channel and virtual channel. However, cable companies do not always reliably transmit PSIP information. Alternatively, CableCards receive the channel mapping and can communicate that to the set-top box.
Digital cable has allowed for out of market televisions to be removed from the basic cable lineup from Channels 2 through 13. They would be moved over to digital cable channels 100 and above for bandwidth preservation. Currently, Comcast Cable outlets in New Jersey and Virginia are adapting this in significantly viewed counties that are bordering nearby television markets.
This section does not cite any references or sources.
Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. (October 2009)
The standard for signal transmission over digital cable television systems in the United States is now fixed as both 64-QAM and 256-QAM (Quadrature Amplitude Modulation), which is specified in SCTE 07, and is part of the DVB standard (but not ATSC). This method carries 38.4 Mbit/s using 256-QAM on a 6 MHz channel, which can carry nearly two full ATSC 19.39 Mbit/s transport streams. Each 6-MHz channel is typically used to carry 712 digital SDTV channels (256-QAM, MPEG2 MP/ML streams of 35 Mbit/s). On many boxes with QAM tuners (most notably the DVR boxes), High Definition versions of local channels and some cable channels are available.
Digital Cable allows for the broadcast of EDTV (480p) as well as HDTV (720p, 1080i, and eventually 1080p). By contrast, analog cable transmits programs solely in the 480i format (the lowest television definition in use today).
The ATSC standards include a provision for 16-VSB transmission over cable at 38.4 Mbit/s, but the encoding has not yet gained wide acceptance. Some MATV systems may carry 8-VSB and QAM signals, mostly in apartment buildings and similar facilities that use a combination of terrestrial antennas and cable distribution sources (such as HITS or "Headend in the Sky", a unit of Comcast that delivers digital channels by satellite to small cable systems).
Digital cable channels typically are allocated above 552MHz, the upper frequency of cable channel 78. (Cable channels above channel 13 are at lower frequencies than UHF broadcast channels with the same number, as seen in North American cable television frequencies.) Between 552 and 750MHz, there is space for 33 6-MHz channels (231396 SDTV channels); when going all the way to 864MHz, there is space for 52 6-MHz channels (364624 SDTV channels).
In the U.S., digital cable systems with 750MHz or greater activated channel capacity are required to comply with a set of SCTE and CEA standards, and to provide CableCARDs to customers that request them.
Cable television in the United States
National Cable and Telecommunications Association - Digital Cable
Digital cable & Digital house
US CATV Channels and Frequencies table (up to channel 78)
US CATV Channels and Frequencies table (comprehensive)
Digital television in North America
ATSC tuners Digital subchannels Virtual channels Distributed transmission system Datacasting (Guide Plus National Datacast UpdateLogic) Metropolitan Television Alliance Grand Alliance
All-Channel Receiver Act SAFER Act Digital channel election Set-top boxes Digital television adapter U.S. Converter Box Coupon Program (boxes, legislation) Analog passthrough DVD recorders Digital video recorders
ATSC Standards (ATSC ATSC-M/H 8VSB A-VSB E-VSB PSIP PMCP full list) Standard-definition TV (480i 576i) Enhanced-definition TV (480p 576p) High-definition TV (720p 1080i 1080p) Serial digital interface Smart antennas (CEA-909)
see Template:American broadcast television
List by country Canada Mexico United Kingdom United States (HDTV transition wireless spectrum auction)
Digital-cable-ready TV (QAM tuners) Interactive-digital-cable-ready TV (OpenCable Application Platform Advanced Common Application Platform) Must-carry Tru2way
Encryption CableCARD Downloadable Conditional Access System
DVB-S (Dish Network GlobeCast World TV Free-to-air receiver Bell TV) DigiCipher 2 (4DTV Shaw Direct) Digital Satellite Service/DVB-S2 (DirecTV)
14:9 Active Format Description Broadcast flag Channel protection ratios HDTV blur Hierarchical modulation Pirate decryption Standards conversion Video on demand
Categories: Digital cableHidden categories: Articles with limited geographic scope USA-centric Articles needing additional references from June 2006 All articles needing additional references Articles needing additional references from October 2009 I am an expert from China Textile and Leather, usually analyzes all kind of industries situation, such as web based contact management , search engine ranking services.
Related Articles -
web based contact management, search engine ranking services,
|
Rate This Article  |
|
|
|
|
|
Do you Agree or Disagree? Have a Comment? POST IT!
| Reader Opinions |
|
|
|
|
|
|
|
|
|
| Author Login |
|
|
 |
Advertiser Login
ADVERTISE HERE NOW!
Limited Time $60 Offer!
90 Days-1.5 Million Views
|
|
TIM FAY
After 60-plus years of living, I am just trying to pass down some of the information that I have lea...more
|
|
|
|
|
LAURA JEEVES
At LeadGenerators, we specialise in content-led Online Marketing Strategies for our clients in the t...more
|
|
|
|
|
ALEX BELSEY
I am the editor of QUAY Magazine, a B2B publication based in the South West of the UK. I am also the...more
|
|
|
|
|
GENE MYERS
Author of four books and two screenplays; frequent magazine contributor. I have four other books "in...more
|
|
|
|
|
SUSAN FRIESEN
Located in the lower mainland of B.C., Susan Friesen is a visionary brand strategist, entrepreneur, ...more
|
|
|
|
|
STEPHEN BYE
Steve Bye is currently a fiction writer, who published his first novel, ‘Looking Forward Through the...more
|
|
|
|
|
SHALINI MITTAL
A postgraduate in Fashion Technology. Shalini is a writer at heart! Writing for her is an expression...more
|
|
|
|
|
ADRIAN JOELE
I have been involved in nutrition and weight management for over 12 years and I like to share my kn...more
|
|
|
|
|
JAMES KENNY
James is a Research Enthusiast that focuses on the understanding of how things work and can be impro...more
|
|
|
|
