The various carpet materials differ in their ability to resist stains and wear. And the higher a carpetâ€™s pile, the more difficult it is to get all the dirt up when vacuuming. Some materials, such as wool and acrylic, also abrade more easily because the yarn does not hold its integrity as well as some other materials. Finally, some carpet materials fade more easily than others when exposed to sunlight. |
Depending on stains and wear, carpeting may need to be replaced every five to ten years or soâ€”obviously, carpet in less- traveled or less heavily used rooms will show less wear than carpet that is on a direct path from the living room to the kitchen, say.
There is little to be done to repair carpet short of replacing it. Patches look tacky. However, if the seams come up because they werenâ€™t glued down properly, or if the tacking strips come loose from the edges, these problems can be easily remedied.
A bit of advice: As a group, carpet installers are more willing than other contractors to take on small jobs and handle minor repairs. They are relatively affordable and are equipped with all the necessary tools and skills, so it usually doesnâ€™t pay to do carpet repair work yourself.
How to Remove Carpet Stains
The most common problem with carpets is staining. Most synthetic carpets have some degree of stain resistanceâ€”name-brand nylon the most of all. Any time a spill is made onto carpeting, the key is to try and remove it as quickly as possible. Results are always best before the stain gets a chance to dry. Sponging water over the affected area will help dilute the stain, but be careful not to spread the stain.
To remove a basic stain:
1. Immediately following a spill, remove any semi-solid material with a spoon and place a clean, white absorbent material such as paper towels, a kitchen towel, or a sponge over the spot and press to draw the liquid away from the carpet fibers. The idea is to blot, not scrub.
Scrubbing will spread the stain and drive it deeper into the material youâ€™re trying to clean. As soon as the absorbent materials are wet, replace them with dry ones and weight them down with a heavy object. Replace them when they grow wet.
red wine stain removal carpet2. Apply a carpet cleaner directly to the stain. Ideally, you would first apply it to a small test spot in a less conspicuous part of the stain and leave on for 10 seconds. This will assure you if the cleaner is safe for your carpet.
3. You may need to treat the area more than once if it is an especially stubborn stain; some stains will never completely come out.
4. When the carpet is clean and has had a chance to dry, gently brush it to restore the carpet pile.
For more info of this topic, check the link below:
carpet stain removal
Related Articles -
carpet stain removal, stain removal auckland, stain removal northshore, stain removal auckland city,