|
Introduction: Network Technology Inc's (NTI) SPLITMUX® DVI/VGA Advanced Quad Screen Splitter with Built-in KVM Switch and Real-Time Video enables four computers to display video simultaneously on one monitor. It can also switch one of the four attached computers to a shared keyboard and mouse for operation and to four additional USB devices. Available display modes include: Quad, Picture in Picture (PiP), Full Screen, Dual, Fade through Black, and Win modes. Below are the steps on how to cascade multiple SPLITMUX-DVI-4(RT) units to expand the number of video signals to 16, which are simultaneously displayed on a single monitor. Items required: - 3 to 5 SPLITMUX-DVI-4(RT) Quad Screen Splitters
- Up to 16 DVI/HDMI video sources
- 1 DVI/HDMI display unit
- DVI and/or DVI to HDMI cables
- USB Type A male to USB Type B male cables
- PS/2 keyboard/mouse or touchpad (USB devices can use the included USB to PS/2 adapter)
Steps: The SPLITMUX-DVI-4(RT) can be cascaded to simultaneously display video from up to 16 sources on a single screen. A master/slave setup is used for this configuration – a master splitter connects to four slave splitters, with each slave splitter connecting to four DVI video sources. The display, keyboard and mouse (or a touch screen monitor) are connected to the output of the master unit. Each input of the master unit must be connected to the output of a slave unit, with each slave unit input connected to a DVI video source. To simultaneously display video from all 16 sources on a single monitor, all five Quad Screen Splitters (1 master, 4 slaves) must have Quad Mode set as the display mode. This can be done using the front panel interface, keyboard/mouse hotkeys, On Screen Display (OSD), or RS232 control. The master unit splits the screen into four, with each quadrant displaying video from one slave. Each slave unit will further split its display quadrant into four, with video from each source taking up a sixteenth of the screen. If less than four Quad Screen Splitters are cascaded, the unused channels on the master splitter will need to be disabled. Example: if two Quad Screen Splitters are cascaded from the master splitter, and connected to inputs one and two, then inputs three and four would need to be disabled. Notes: - Higher refresh rates output smoother video, but the best frame rate that can be displayed for each quadrant on the display is about 12 frames/sec for the SPLITMUX-DVI-4, and 60 frames/sec for the SPLITMUX-DVI-4RT.
- Display modes (Quad, Picture in Picture, Dual, Fullscreen etc.) of slaves and masters can be individually set, combined, and switched when cascading multiple units. Any combination is possible.
- Example set up:
- Master unit: Quad mode
- Slave 1: Picture in Picture
- Slave 2: Fullscreen
- Slave 3: Quad
- Slave 4: Dual
- Use a programmable keyboard for comfortable switching of cascaded units. Refer to the SPLITMUX-DVI-4 manual (page 75) or the SPLITMUX-DVI-4RT manual (page 100) for more information on hotkey switching of cascaded units.
About Network Technologies Inc
Network Technologies Inc (NTI) is a leading manufacturer of high quality IT and A/V solutions. NTI products (extenders via CAT5, audio/video matrix switches, video splitters, KVM drawers, KVM switches, and environment monitoring systems) are designed, manufactured and tested at the company headquarters in Aurora, Ohio. For more information, visit: www.networktechinc.com.
Related Articles -
multiviewer, quad, screen, splitter, display, monitor, HDMI, video, audio, multiple, KVM, switch, cascade, simultaneous, real-time,
|
