A multifunctional printer and is a full color comprise of a konica imaging unit. This integrates a development unit, charger, photo conductor and conductor is integrated into a single unit. It is not cumbersome to replace it. This will be done if necessary. The toners and the imaging unit are different. It is possible to use an unit even if the bottle has been used up. This is the reason why Konica Minolta is putting in constant efforts to increase the life of such units. This is the reason why the service life is three times longer than the original one. The type of models has evolved in technology from the one that was used in the year 2000. This has improved the mixing system for circulation of the mixing system. It further contributes to the development unit and also changes the electrodes of a charger. The 56UA53040 Upper Fuser Roller improves an overcoat layer of a photoconductor drum and adopts a toner that contains an agent for lubrication. It is from the aspect of the life cycle of a product that extends the life of service. This also contributes to the protection of an environment. This will pose a reduction in mechanical waste. The toner has spent time on the carrier that has occurred at the ability to charge it electrically. This has reduced the stress on the development unit. This has also caused a scattering to the toner and has forged it to become all the more worse. There has to be a way to solve the problems. This has made an effort to reduce stress that has contributed to develop the unit. The developer circulates along within two vertical axes with the help of a mixing screw. There has also been a feed screw in the unit of development. The weight of the developer has been located near the feed screw that has been installed on the upper side of the stress. It has also solved the problem of a dividing a member that has been inserted into it. This is done in between a feed screw as well as a mixing screw that has been modified. It has useful in the A03UR70711 Developer Unit. As a result of the developer has been circulating smoothly along with two vertical axes. The developer requires to be circulated smoothly along with two vertical axes. The developer near the mixing screws receives less stress from the point of view of the developer. The developer needs a mixing screw that will give less stress from the developer that is available near a feed screw. The mixing screw has also reduced the amount of torque that has been achieved by it. In addition to it, the developed unit has considerably reduced by 30%. The 4049212 Transfer Belt Unit is made up of electrodes of a thin array. This has been located on the drum side of the photo conductor that also charges the drum electrically. The electric discharge contaminates a pin point array of electrodes. This will also decrease the scope of an uneven charging.
Related Articles -
56UA53040 Upper Fuser Roller, konica imaging unit, A03UR70711 Developer Unit, 4049212 Transfer Belt Unit,
|