When upgrading or adding new electrical components to your boat it goes without saying to be careful, especially when working with AC current. When in doubt always use a licensed Marine Electrician and always use "Marine Grade" wiring. Normally, the average boater will replace worn battery cables, work to upgrade the electrical panel, changing fuses, or simply adding lights, GPS, or some other boating want. It is recommended you use a Marine Grade wiring for your boat, but what does Marine Grade mean? Marine Grade wiring is specifically designed to exceed all test standards for cold bend, moisture and oil resistance, heat shock, and flammability. Marine Grade wiring is easy to install and ultimately the least expensive way to wire your boat. Non Marine Grade wiring is cheaper, but will need to be replaced more frequently and is not approved for the corrosive marine environment. The last thing you will want is faulty wiring when you are out to sea or even out on a lake or river. When choosing the wiring you will want to consider what is the opacity [the safe current capacity of the wire before damage will occur with the installation]. In addition, you will want to consider the ampacity with regard to location on the boat. In the engine room, you can see a 10-20% drop in ampacity [due to heat and the specific microclimate of the engine area]. This means for a standard 16 AWG gauge wire the ampacity outside of an engine space is 25 Amps; however, inside the engine space it is only 21 Amps. The most commonly replaced boat electrical parts are Wire Connectors, Terminals, Ties, Clamps, Accessories, Circuit Breakers, Fuses, Panels, Terminal Blocks, Marine Batteries, Battery Cable, Switches and Accessories, Navigation and Exterior Lights, Interior Lights, Electrical switches, Battery Chargers, and Inverters. You may also use various electrical tools such as Crimpers, solder guns, butane torches, and flashlights when addressing electrical problems. Most of these parts face wear and tear as they remain in use quite continuously. Therefore, you must be careful about their status at any point of time. When replacing any of the above electrical components always ask questions. While you do not need a complete understanding of how and why things work specifically, it is always best to err on the side of caution and safety. Purchasing these electrical parts also requires closer attention. You should not buy them from anywhere else, as you would be required to make sure that the quality of these parts is always good and dependable. Therefore, you should find a store at your own place so that you can get assistance whenever you would need. At present, both online and offline stores are available and that is why you can buy your requirements from these stores. Due to the assured quality reasons, you can prefer buying these electrical components directly from the manufacturers and that is where the online stores become important. You can visit the website and fulfill all the norms while buying things from there.
Related Articles -
MarineHQ, Marine, Boat, steering cables, boat captains chairs, gas can,
|