Most furnace systems comprise of two basic units that make up the system. One unit is the area that actually generates the heat for the system. The second unit is the blower, which works to distribute the warm air though the home. In order for a system to work well, these two units must be in good condition. If they are not, then the unit will need to undergo Brampton furnace repair work before it can be used effectively and efficiently. Very often, a homeowner may decide that they wish to handle their system's Brampton furnace repair work on their own. This can often be accomplished quite easily providing the homeowner has a few standard tools, some extra time, and a bit of patience. Ideally, the best time that such repair work should be undertaken is in the spring or early fall months when the unit is not in use. By working on a unit during these times, it can also be easier to schedule a professional repairperson if repairs that are more extensive need to be done to the system. One of the main things that will need to be done during Brampton furnace repair work is checking the burner portion of the system. Since the burner is one of the most critical elements of the furnace, it is important that it is lighting properly. Most burners are lit by a pilot light. The flames of the burner generally are triggered to light by a need for heat generated from the thermostat. It is a good idea to examine the coloring of the burner flames when they are lit. They should be blue and burning steadily. If they are not, the unit may need to have the burner cleaned. Cleaning the burner is a Brampton furnace repair issue that many people may be wary of trying. However, for some homeowners, it is not a difficult task. The first thing they will need to do is turn the thermostat to low. Next, the gas to the unit should be turned off and the line should be unhooked from the unit. The manifold will have to be removed from the firebox so that all the individual burners within it can be cleaned using a wire brush. The individual burner tubes will also need to be cleaned with a pipe cleaner. Once this is completed, it is necessary to rid the manifold of all the excess dirt that has been shaken loose before putting the unit back together. It should then be able to be switched back up and the flames should return to a proper color and look. If this does not correct the problem or a person does not feel comfortable attempting this repair on his or her own, a professional should be contacted. The other element that will need Brampton furnace repair work is the blower section of the system. The blower is made up of a fan and motor. The fan is generally connected to the motor through pulleys and a fan belt. Making sure the motor is in good working order is essential for the blower unit to work. Most motors have vents where air is pulled into the motor to keep it from overheating. Since dirt can often clog these areas, it is important to make sure they are clean. The motor may also have ports where oil needs to be added to keep the system lubricated so the bearings within the unit do not wear out. Just a couple of drops of non-detergent motor oil will be sufficient. The fan should be inspected for signs of damage and it should be cleaned using a stiff brush. It is important to check that the fan can move freely and that it is secure on the shaft it is attached to. Finally, the fan belt should be checked and replaced if it is worn, damaged or frayed.
Related Articles -
furnace, repair,
|