When it comes to the safety of your customers or your employees, non-slip stair treads are one of the easiest safety tools to install. It doesn’t take much work to get the treads in place though you may want to do it over a weekend to allow the adhesive time to set. Preparation You’ll want to keep the treads and the stairs above 70 degrees F for at least 48 hours before you install the treads. This will ensure the adhesive will work properly and the treads won’t curl during installation. If your stairs are wood, then make sure they are all attached well, nailing down anything that wiggles. Finally, clean the steps to remove any dirt or oil that would interfere with the adhesive’s ability to hold on. Installation The treads will come longer than the stair is wide, so you’ll need to cut them down to size with a utility knife. You can install two treads on each stair. Use a pencil to mark the place where you want the tread to sit. That way you get an even and uniform look on each stair. Spread the back of both treads with adhesive making sure to cover the entire tread. In order for the treads to last, they need to be free of air holes or pockets. Set the front edge of the tread first and then roll the rest of it into place. Use a paint roller with a firm, foam shell to roll the treads flat. Give the adhesive 24 hours to cure before walking on the stairs. If you notice any holes due to dips in the stairs, fill them with caulk to keep the non-slip stair treads from lifting. If the edges lift, the treads themselves become tripping hazards and must be removed and a new tread installed. http://www.amstep.com/index.html With over 100 years of experience, Amstep Products Amstep Products and its predecessors have manufactured anti-slip stair treads and stair nosings better and longer than any company, anywhere. - See more at: http://www.amstep.com/about.html#sthash.DJgNKDat.dpuf
Related Articles -
non-slip, stair, treads,
|