|
Hydrographics has and is replacing, pretty much all other methods of printing design forms on different bodies these days. One of the major advantages is that is not very expensive, fits into all types of shapes and yields very good results. With rising demand it is recommended that you know the correct procedure of how to hydro dip such that it benefits you’re designing process. You’ll need dipping kits, activators and films alongside to undertake the designing process. How to hydro dip? Performing hydro dip process is easy. If you follow instructions carefully it will not be a problem of any sort, in implementing the design. Here’s how you could successfully carry out such a process. • Sand item on which you want to apply the film. • Use silicon remover spray and clean the piece of item. • Recognize the material of making of the item. • Spray primer evenly. Do not touch until it’s completely dry. • Use a mask that comes with dipping kit. • Now you will need to spray WTP based stuff over the item. Spray it uniformly all over. • Apply two coats of spray base such that there is an interval of 10 minutes between each coating applied. • The piece should be completely covered with color. Wait for it to dry off. Again make sure you are wearing the mask that is provided. • Prepare film by placing the item above it and leave 10 cm extra on each side. Tape the film on all sides and cut wherever necessary. • Then place film in water. Temperature of water should be between 30 – 34 degrees. Place film in water from any one corner. Avoid bubbles being formed. Wait for about one to two minutes depending on the nature of the film and temperature of water. • Spray activator evenly on film and use masks that comes with dipping kits. • Immerse the piece at 45 degrees to avoid bubbles. • Wash item nicely for about 5 minutes. Then wait for it to dry. • Use a clear coat as per instructions and don’t touch it for at least 8 hours. This time is for drying the piece. • Your item will be ready with new design. It can be said that the above steps will carefully guide you on how to hydro dip and also get the right design on an item. It is not a very expensive method and has good results.
Diy Dip - Hgarts.com such that it benefits you’re designing process. You’ll need dipping kits, activators and films alongside to undertake the designing process click this.
Related Articles -
Water Transfer Printing Activator, Hydro Dip,
| 
