How to Add GameCube LEDs The GameCube gaming console was released in November 2001, before the LED light trend hit gaming enthusiasts, so a new trend of making old consoles such as the GameCube modern with LED lights is becoming more and more popular. The most popular modification of the GameCube hardware involves adding LED lights to the controllers, since they are easier to obtain than a new console if you mess up and damage some interior elements. Instructions 1 Remove the six screws from the back of the clear GameCube controller with the Gamebit screwdriver. Set aside the screws. Pull the controller's front and back faceplates away from one another; if they are not extremely dirty, they will pull apart with minimal effort. Set aside the back face plate with the screws and lay the front faceplate carefully so that the interior components are facing up towards you. 2 Prepare about two 4-inch lengths of the 24-gauge electric wire for soldering to the two leads located on the right side of the controller. The existing white wire is positive, while the black is negative. 3.Place your LED lights where you want them to sit inside your controller. Before making any positions permanent, place the back side of the controller in its place without securing it entirely, so you can ensure that you like how it looks. It is recommended to place the LEDs on both sides of the rumble pack. 4 Solder the end of the first wire to the left lead on the circuit board, and the end of the second wire to the lead on the right. These leads are connected to the rumble pack feature, so the LEDs will blink in accordance with the controller's vibration. 5 Grasp the wire on the left in your hand, and attach it to the left LED light by wrapping the center of the wire around the LED's prongs, and attaching the remainder of the wire to the resistor. Use the electrical tape to attach the resistor directly under the rumble pack. Repeat this step to connect the LED on the right side of the controller. 6 Wrap all wires with electrical tape, and secure them to the body of the controller if there is excess wire. You do not want wire being in the way of any buttons, or the rumble pack. Tips & Warnings Only attempt this modification if you have some sort of previous electric experience to avoid permanent damage to the GameCube's hardware. Scratching or soldering your circuit board at all can eradicate the entire controller. Always discharge static on your hands while working with computer components by touching base metal. Dreambox DM7080HD dm7080HD cheap dreambox DM8000HD led wall washer light led pixell light LED Underwater LightLED Spot Light LED Spot Light dm8000 DM7080 HD Dreambox DM8000 HD DM8000 HD DM8000 dreambox dm7020 HD 7020 HD DM7020 HD DM500 HD DM500 HD V2 Dreambox dm500 HD DM800 HD SE v2 dreambox dm800 HD SE V2 Dreambox dm800 HD SE V2 DM800 HD SE Dreambox DM800 HD SE DM800 HD SE wholesale usb flash drive wholesale lenovo cellphone Dreambox DM7080HD decoder DM7020HD V2 DECODER DREAMBOX
Related Articles -
led, wall, washer, light,
|