|
How to Reset the Blinking Light on a Whirlpool Dishwasher If you own a Whirlpool dishwasher, you sometimes may see the LED light near the control panel blink repeatedly while the appliance is running. The blinking light typically indicates water heat was not detected during the cycle. You can stop the blinking and attempt to fix the problem by running a diagnostic cycle using the control panel on your dishwasher. Instructions 1 Locate the display on your Whirlpool dishwasher, and confirm the light is still blinking. 2 Press the "Heated Dry" button, then quickly press the "Normal" button. 3.Press the "Heated Dry" button again, and press the "Normal" button again to enter the diagnostic mode. 4 Close the dishwasher door if it is open, and the diagnostic cycle will run. 5 Check the dishwasher after 30 minutes to make sure the diagnostic cycle is complete, in which case the light should no longer be blinking. Dreambox store wholesale dreambox dm7080HD cheap dreambox DM8000HD led wall washer light led pixell light LED Underwater LightLED Spot Light LED Spot Light dm8000 DM7080 HD Dreambox DM8000 HD DM8000 HD DM8000 dreambox dm7020 HD 7020 HD DM7020 HD DM500 HD DM500 HD V2 Dreambox dm500 HD DM800 HD SE v2 dreambox dm800 HD SE V2 Dreambox dm800 HD SE V2 DM800 HD SE Dreambox DM800 HD SE DM800 HD SE wholesale usb flash drive wholesale leaf jewelry wholesale lenovo cellphone Dreambox DM7080HD decoder DM7020HD V2 DECODER DREAMBOX
Related Articles -
LED, Wall, washer, light,
| 
