Sometimes there is no need to seek the help of an expert when it comes to the Cork flooring installation since you can follow the simple guidelines. As long as you have the right equipments, you will be good to go. Some of the necessary tools that you should have with you include the utility knife, painters stick, rubber mallet, deep dish paint and the framing square just to name a few. |
When you have received the cork tiles from your dealer, do not start the Cork underlayment process immediately. The first thing you are required to do is remove them from their boxes and let them stay for a period of four days on average. This allows them to acclimate to the prevalent temperature of your room. In the event that you realize that the tiles seem not to be in the best state, do not go ahead to install them since doing so means you have accepted them they way they are from the dealer. Instead, you can get the sellers informed about it so that they get you better ones. After you have taken into consideration the above concerns, you can proceed with the process.
To begin with, you will have to layout the pattern just like you would do with any other floor. For wall installation, you will have to mark lines that will serve as the guide. With the use of paintbrush, apply the adhesive to the room’s perimeter. In case there is some adhesive on the wall, remove it using rag or a towel that has some moisture. Sometimes you might realize paint that has dried at some point. This needs to be removed by rubbing gently.
The next Cork underlaymentstep will be the application of the adhesive to your substrate using the painter roller that has a medium nap type refill. Do it the same way you would have done when you are painting a substrate. Do not worry about the substrate that will be on the chalk lines since it will dry off itself within some time. When dry, it will turn clear and feels tacky when you give it a touch. In most cases, this will only take an hour on average. If it will not be dry by then, you have to give it some time to have it in the right state.
When the adhesive is dry, align the tiles to the edge of the chalk lines created very carefully. Once your tiles touch the adhesive they will automatically, grab the substrate in question. Ifyou get them aligned wrongly, you will have to peel the substrate in a careful manner. You can use the putty to make it easier for you to do so. With the slicing motion, get the tiles peeled up very slowly. When you are through, you will have to do the reapplication of the adhesive to the areas that have been affected.
Cork flooring installation is not a demanding task as long as you have the right tools for doing the job. The moment you can get the first tile aligned in the right manner, the rest of the tiles will automatically fit in the process. However, to be on the safe side, begin with getting the help from your http://cancork.com/cork-underlayment.html Cork underlayment experts so that you do not end up with the small pieces at the end.
Related Articles -
Cork flooring installation, Cork underlayment,