Industrial heaters can do a tremendous job for your company. An introduction to air heating is something that every business owner needs to become familiar with. You want to maximize your heating efficiency and keep the bill as low as you possibly can. The air in a commercial building can be heated in numerous ways. Quartz and ceramic heaters can be used, as can open-coil heaters, or tubular and strip heaters. The choice of which one is best for your facility depends on such factors as air velocity, volume and air pressure. In order to lengthen the life of your industrial heaters, it is advisable that you use a zero-cross fired or a phase-angle fired power control. The manner that air heaters work is by transmitting heat into the passing air or fluid. Air that has not been filtered, could possibly contain trace elements of water, dirt or grease, which could reduce the longevity of the unit. This is particularly the case for open-coil air industrial heaters. It is important to have air flow over the heating element for a period of time after the heater is no longer in use. To make sure this takes place, make use of a time delay relay. If the temperature sensor on the heating system is not in close proximity to the heating element, what you can do is to position an over-temperature sensor near the air heater to accomplish this. It is a wise idea to use a flow switch to prevent overheating from occurring in the event that there is not sufficient airflow. When it comes to industrial heaters, you need to think about a temperature controller, a temperature sensor and electrical power switching. Get advice from a qualified heating and cooling professional or engineer if this is all very new to you. Open-coil heaters work at their highest capacity when their air velocities are below 80 FPM. When the air velocity becomes higher than that, the coils are more likely to touch each other. This can lead to them shorting out. These air heaters have a low mass and also a speedy response time. Tubular and strip heating systems are available in several shapes. These units produce hot air and are often used for ovens and as comfort heaters. These units work best if the process temperature in a building dips lower than 500 degrees Fahrenheit. Choose a finned strip or tubular model. For higher temperatures, such as heating up to 1200 degrees Fahrenheit, choose a unit without fins. Another option in industrial heaters is quartz and ceramic air heating systems. This type work up to 1500 degrees Fahrenheit. They are most often used for drying purposes, as well as heat shrinking, adhesive curing, work with plastics and the industry for medical packaging. Are you looking for a wide variety of high quality Industrial Heaters Baton Rouge? Contact the professional staff at Ross & Pethtel, Inc. by visiting http://rosspethtel.com and they will help you find the right unit for your business.
Related Articles -
Industrial, Heaters, Baton, Rouge,
|