|
Aerated concrete block equipment is made of iron or steel, steel rust, moisture, temperature and pH value and other factors are the key factors to influence its Flotation machineantiseptic, then how to avoid it rust? The new strategy of anti-corrosion of aerated concrete block equipment of our.ball mill manufacturer One, the coating must be able to withstand aerated concrete slurry and embryo high alkalinity and high temperature, high humidity, no pulverization, flow, evaporation, brittle fracture or other deterioration. Two, after autoclaved curing, the coating should be firmly bonded with steel and aerated concrete block equipment, in the test, failure should occur in aerated conbeneficiation plantcrete block equipment, but can not occur between the coating and the steel bar and aerated concrete block. Three, coating must have processing, such as soaking bath penetration coating, coating must have enough storage time, at this time, no settlement and segregation, no condensation, not conjunctiva, not bad, can keep good fluidity and viscosity. Four, no matter what method with invasion of Light Weight Block Machinecoating, coating must be easily adhesion to the steel, and the hard coating layer thickness is formed on the surface of steel, ensure the coating does not damage in handling and assembly process of the reinforced mesh, the elastic modulus of coatings should be greater than the aerated concrete block equipment,Aerated Lightweight Brick Machine to ensure that the board has good performance of structure under long-term load. Anti-corrosion ability five, coating should reach the required standard, namely, should have the impermeability, can effectively preventaac line the penetration of oxygen and other corrosive masonry and substance, itself is not corrosive to steel. Six, low cost, raw material is easy to solve, Autoclaved Aerated Concrete machinerythe production process is easy to master and control
Related Articles -
Aerated, concrete, block, equipment, is, made, of, iron, or, steel,
|
