|
As many of us know, a cooling tower is used in industrial air conditioning systems, usually in large factories and other buildings that use a lot of heat and energy, and needs to be cooled. The cooling tower does what its name suggestions, answer which cools the hot condenser cooling system, the tower is provided at the end point of the heat transfer process and that after the cooling tower the excess heat is then transferred to the atmosphere. A tower usually comes in one of two designs, cross flow and counter flow design. Cross flow tower With cross flow tower, the water flow has to be a very specific angle to the air flow in order to work, and this angle is a right angle. A cooling tower that uses cross-flow technology will be in the form of cash and it works by pumping hot water to the top of the tower, which is then distributed to the sides of the tower and dropped through small holes there. Then plastic air intake grilles that can be found on the side of the tower allowing water out while dropping and thereafter , air is sucked and then from the outside in the cooling tower by several fans . This air, after contacting the water drip is then cooled and falls to the bottom of the tower. This chilled water is pumped out again, and circulate through the cooler, then the excess heat is transferred to water cooler again, and the warm water is once again transferred to the top of the tower which means that the cycle begins again. The counter flow tower The second type of tower, countercurrent flow, works a little differently as they have over the air flowing directly into the water flow. Although the water follows the same pattern as cooling towers, cross flow as the water is allowed to move. However, these towers are more funnel-shaped and there is only one fan in the center of the tower instead of several and equipped under the fan is the distributor of rotating water pipes. Water pipes water distributor launch of a hand and this action turns the distributor. Thanks to the distributor, the water is uniformly dropped over the air inlet vents and as water droplets which comply with the current of air and the air cools the water. The water collected below the bottom of the cooling tower is pumped into the cooler is heated again and then returns to the cooling tower. The purpose of a cooling tower is obviously cold water and while this was only a brief introduction to the cooling towers there is a lot of information about them online. So if you want to know more about them start looking online and you will be able to discover more about them, their history, the reasons for them and even how you can participate in the cooling tower companies is really up to you. Crystal Cooling Towers manufacturer, exporters and suppliers of Cooling Tower and frp Cooling Tower.
Related Articles -
Cooling Tower, frp Cooling Tower,
|
