Damp walls at high level or in an isolated area? Is the damp area manifesting internally at a high level? Check outside for condensation overflow or toilet overflow pipes dripping down the brickwork. Damp proofing products can be installed quickly and efficiently, and are a cost effective solution. You have tried to paint it over and over again but it just keeps flaking off the walls? Maybe you have decided to bite the bullet and call in a damp proof expert to give you advice? That's a great idea but best to know if the damp proof expert is giving you the right advice. It could be a time consuming and expensive mistake if you do not know how to damp proof in theory. the main culprit in the way of house damp solutions here is the leaking gutter or down pipe, same again stop the external source of damp and your problem will be rectified. Damp walls can also be a problem and water ingress into your property can also be through structural defects. Another problem which you may encounter is condensation mould cause by lack of ventilation in the property. Usually found behind cupboards or in the corners, condensation problems look like black spots and can easily be confused with rising damp. Once again ventilation is a job for an expert and modern properties which are governed to be more air tight do suffer as a result. The biggest problem in the damp proof diagnosis is high ground levels over the top of your existing damp proof course or lack of a damp proof course in the first instance. If you do have high external ground levels then you must lower them otherwise you could be dealing with more than damp walls, you could in a worst case scenario have water entering your property. If you cannot remove the ground then you will need to use a waterproofing technique like you would in a basement. A qualified surveyor should be able to point you in the right direct here as with the structural defects.this is more difficult to ascertain so here is are a few things to look at: Chimney flashing or other lead flashings under windows, cracks in the walls - may need structural repair - consult engineer, defective pointing- could be a major problem - need professional advice, loose tiles - obviously a instant source of dampness in structure needs, bridging of a cavity wall with rubble. All the above except the cavity wall bridging may be able to be visually checked as a source of damp problems. However it may be worth to make sure getting a chartered surveyor to provide you with a full report.So we first need to identify the damp areas of your job and what is causing them. Now this can be tricky but we can eliminate some obvious damp proofing elements before we pay for someone to come and and consult us. roof ventilation is essential. The constant source of water against your brick work can be drawn into your internal finishes and manifest like a damp patch or salts coming through. This should be obvious so stop it immediately and then once this has been achieved then it will just be a matter of re-decorating your damp wall.
Related Articles -
house damp solutions, roof ventilation,
|