|
All resilient floors other than cork may be polished with water-based floor polishes. Water-based polishes for resilient floors are sometimes referred to as “waxes” or “finishes.” Such polishes are really clear, water-based acrylic (or other synthetic polymer) finishes that contain no wax, which is solvent-based. Solvent-based polishes or waxes can be used on some resilient floors, but not on asphalt or rubber, in which they will cause severe softening or running of colors. If homeowner do not know what the resilient floors are made of, take no chances and use only water-based polishes, finishes, or sealants. Test any solvent-based floor polishing St Louis product in an inconspicuous area before using it on the floors. When homeowner can find out the floor manufacturers' instructions about waxes or polishes and follow them. Before polishing or sealing, thoroughly clean the floor. First sweep or vacuum it, and then wash it. Homeowner need not remove the old wax or polish every time homeowner put down new. Removing old polish after three or four coats will be sufficient to prevent a difficult-to- remove buildup or the dulling that comes when dirt is embedded in the old coats. To remove old polish, homeowner may use a solution of ¼ cup of detergent plus 1/4 cup of ammonia to every half a gallon of water. But homeowner must rinse thoroughly after doing so, or ammonia will remain on the floor and cause the new coat to go on unevenly. Or homeowner may use a commercial product designed to remove this type of polish, following the instructions on the product. Do not use removers for solvent- based waxes unless homeowner has determined that solvents are safe on the flooring and have used a solvent-based wax. Apply polish or sealant with a sponge mop or a liquid-floor-wax applicator. Follow the product instructions. Often it will be convenient to pour the polish or sealant into a shallow pan, such as a fresh paint tray or an aluminum baking pan, not directly onto the floor. Dip the mop or applicator into the finish and apply a thin, even coat to the floor. An excess will not only look bad; it will also attract and hold dirt that is ground into it, and it will be harder to remove. Two coats give greater shine and protection than one. Water-based floor polishing St Louis for resilient floors are all “self-polishing” these days—that is, homeowner need not buff them. But if homeowner likes a higher shines, he can do this with a lamb's- wool pad on a stick, any other soft, clean material, or a buffing machine. Rub quickly and lightly until the surface glows. Turn the cloth or pad as soon as the side homeowner is working on becomes soiled. Reading the reviews provided by the author is one of the best ways to gain necessary information on St Louis Painting
Related Articles -
floor, polishing, St, Louis,
|
