|
Saying goes: "One born of nine children, nine sons, all different." But for a particular brand of car, because the use of the same parts, a uniform quality control standards, and in the same production line , according to a strict process for assembly, and therefore the performance index for each engine is almost not there is any difference. However, in actual use, the service life of each engine are different, some use the 500 000 km without major repairs, while others are less than 100 000 km, the engine appeared channeling smoke Burning oil And so on. There such a big difference, in the end is what causes it? Car engine in use in the formation of such a big difference, the key is that each owner Driving habits And the proper use and maintenance of vehicles, these factors will determine the car engine overhaul mileage (Gallery Forum). Following several high-end cars on the proper use of methods and precautions to extend engine life. 1. Attention to the new car to go together in the car to go together during the period of the engine with each other within the uneven surface of some parts will be rubbed off, and gradually form a relatively smooth face, to improve the surface quality of parts and with precision, to withstand normal workload. So take the combined work of the engine during the period directly related to engine life. Vehicles together during the walk is important to note: (1) non-high speed. Car in the engine block speed may not exceed the maximum speed of 70%. Does not allow long high speed. (2) non-overload operation, does not allow overloading. Once the engine is not working smoothly, and immediately changed into the low block. (3) the engine just after starting, not allowed to slam on the accelerator pedal until the temperature reaches normal operating temperature, then a smooth start. Must start with a block. (4) not to bad roads, reduce vibration and shock. Should be reduced in moving the overload caused by sudden acceleration phenomenon, such as emergency Brake , Long braking or engine braking and so on. Try to choose a good road uniform traffic, go together best. (5) Note that the engine Coolant Temperature, lubricating oil and other fluid levels, found that failure to timely rule. (6) after the close of walking together, walking together on the car for a maintenance. 2. Adhere to the first warm up, after the start of some truck drivers at the start, the often tight tread love kicks Accelerator , Let the engine running fast. As everyone knows, this will cause great damage to engine components. For engine starting (especially cold start), the lower engine operating temperature, the surface of the internal parts are not up to full lubrication, if the engine high-load work at this time will make the internal parts Wear and tear Increase, change with the normal clearance. Good driving habits should start in the engine after the first preheating the engine coolant reaches the normal operating temperature (at least should be to achieve 50 above) before starting. 3. Off to a smooth start to use the low block, while ensuring fast start, smooth key is whether the oil off with properly. When the clutch pedal in a relaxed, "a fast, two stops, three behind, four complete song" several processes that start when you start, the clutch pedal quickly relax; in the clutch in a semi-clutch state, a little pause, with due refueling; then clutch pedal and then slowly relax until the clutch is fully engaged; vehicle after a smooth start, finished fast loose clutch pedal free travel. The above process should be completed quickly, which usually rely on more training. Clutch clutch half the time not too long, so as to avoid excessive clutch wear. Of course, all these are equipped with automatic clutch operation for Transmission The car is has been thrown away. 4. On proper driving habits driving many people are not willing to fuel the process, while complicated and varied urban highways, the speed can not give up; the other hand, mistakenly believe that the smaller and more fuel-efficient engine load, so the engine always result in Idle , And operate under low load conditions. We are high quality suppliers, our products such as centrifugal casting , China lost wax moulding for oversee buyer. To know more, please visits lost wax casting.
Related Articles -
centrifugal casting, China lost wax moulding,
|
