Typically whenever we imagine a flat iron we believe of just hair straightening. However, using the right technique a flat iron may also be used to turnover and curl your own hair. The secret is to get a flat iron with plates which are as near to 1" inch as is possible and when your own hair is short then even smaller. |
To start you have to make sure that your flat iron is most effective for the hair type. In case your hair is difficult to straighten then the titanium product such as the BabylissPro Nano Titanium may be the right choice. Alternatively, in case your hair is finer rather than as hard to straighten then the tourmaline product might be the ideal solution. Nevertheless this does not necessarily mean that you must go out and purchase a brand new flat iron if you currently have one; instead try adjusting the temperature with higher settings for thick hair and the other way around.
Next you have to use a thermal heat styling product. This works as a protective barrier involving the hot plates as well as your hair. Without one you operate the potential risk of damaging your own hair, which can cause drying and breakage. There are many products available so locate one that you like. In case you are still looking then you definitely might try the Miracle Leave-In product by 'It's a 10'. This can be a great choice because it is a flat iron spray, thermal protector and stops breakage while adding shine.
Lastly before we obtain started a couple of important tips. You need to never flat iron your own hair after it is dirty. The greatest results originate from freshly washed hair which is dry. Although, it will not make much difference whether you blow dry your own hair or allow it to dry naturally. Yet, blow drying comes with the potential risk of damaging your own hair too.
1. Hair Straightening
The very first thing you must do is brush or comb via your hair and after that put it into sections. The simplest and fastest approach is to get your hair on top of the top twist it around and put inside a clip. Secondly, section throughout the upper a part of your ears and again twist it around and put inside a clip. This can leave all of the hair from the ears right down to the rear of the neck out and prepared for straightening. It is best to start from your bottom working your path up so you complete using the top area of the head last.
Now comb with the section which is overlooked again. This is very important as if you will find tangles your hair will be unable to smoothly go through the plates causing snagging and pulling. In case your hair is extremely curly or frizzy you will have to comb each section before running the flat iron across it. Next grab a part of the hair approximately 1" inch across and put the flat iron as near to the root as is possible ensuring that you may not burn your scalp. Generally, in regards to a ¼ inch from the scalp is better and do not take excessive hair with the flat iron at once. Salon results originate from smaller quantities of hair where each strand has the capacity to glide evenly involving the plates.
Since you now possess a portion of hair involving the plates start pulling the flat iron through. You must not be squeezing the plates together very hard. The aim would be to enable the hair to freely glide involving the plates. If this sounds like not happening you might have excessive hair that you will be attempting to pull through at the same time - try dividing your section in two.
The following and many important part is definitely the speed where you might be pulling the flat iron via your hair. In case you are pulling too rapidly you simply will not obtain the results that you would like and in case you are pulling too slowly you operate the potential risk of damaging your own hair. A great guideline if you are first learning would be to count out loud "one thousand one, one thousand two, one thousand three" and move the flat iron based on this speed. In case your hair is incredibly curly and harder to straighten then slow this speed down a bit. Once you get towards the end from the hair hold it simply slightly longer. This can make sure you get perfectly clean edges.
Hair flipping, or sometimes known as flicking, is a terrific way to find some good movement around the ends from the hair. Whether you flip your hair inward or outward will not alter the technique just the rotation from the wrist.
To start you follow all the same steps as outlined within the straightening section. You desire to actually start in the root to ensure that the remainder of the hair is smooth and silky using the flip being only around the ends. Make sure to pull through smaller sections and count out loud to keep a sufficient speed. Once you get nearer to the ends turn your wrist either inward or outward forcing your hair now to glide with the plates in an angle. Remember movement from the hair happens based on in which the heated plates are; therefore the more you turn your wrist the stronger the flip.
The key to some perfect flip would be to slow the rate down slightly, while continuing to transform the wrist. It is important would be to have continuous movement much like you might be walking with the hair, but don't forget about the tension involving the plates at this particular will leave marks within the hair (they almost seem like lines and you also don't want that). The movement is steady having an even tension in a slow speed.
Curling your hair having a flat iron is among the most difficult method to master. However, when you obtain the hang from it you will find that it truly isn't very difficult. Again you are going to begin with similar steps as outlined within the straightening section. You will want to determine where you would want to put the curls. Would you like tight curls beginning with the top of the the top or loose wavy curls that start about 50 % way down. It is a great idea to start in the root from the hair because this will make sure a general polished look as opposed to just starting in which you want the curl.
Section your hair as indicated previously taking approximately 1" inch and placing it between the plates. Now when you wish to start the curl turn the flat iron either inward or outward, based on the direction from the curl that you would like, and begin rolling it using the hair loosely around it. Remember you desire the flat iron to become constantly moving so that you are rolling it within the palm of the hand, as the hair is evenly dealing with the plates. The tighter you retain the hair and roll the flat iron the tighter the curls. Usually do not pull around the hair or hold it involving the plates for long periods of your time. In case your hair is harder to curl you will have to hold it slightly longer, however, not a lot more than two seconds.
In conclusion, always make use of a thermal protector on your own hair. This really is imperative to make sure that no damage is performed throughout this process. Also, attempt to match the flat iron for your specific hair type or work together with the temperature setting to obtain optimal results. These techniques take a small amount of time for you to master, but when you receive it you will get beautiful salon quality styles that last.
For more information about wholesale flat irons,simply visit our website.
Related Articles -
flat irons, hair straighteners,