|
1. Mill to be fixed installations, while power machine mill pulley and pulley axis should be parallel to the two drive pulley groove to be in the same straight line, otherwise, not only speed up the mechanical damage, and easy to belt out. 2. If you need restructuring pulley, must meet the grinder spindle speed computing needs. Can not arbitrarily increase the spindle speed, when more than 15% of rated speed, it will cause severe vibration machine. 3. Carefully in advance of the raw materials to clean-up, if necessary, sift or select, to prevent iron, stone, etc. into the machine. 4. Before each use, should open the mill cover and check for damage various parts of the machine, especially the rotor openings Pin Is intact, the connection is loose. Upon confirmation of intact, then secured the lid, screw into the door on the hand wheel. Drag the belt by hand to check whether the flexible moving parts, any abnormal sound and card touch and so on. 5. The machine starts, need to idle 2-3min, to be operating normally after gradually feeding. 6. The operator should be fastened cuffs, wearing masks, work gloves is prohibited; feed mill should be standing on the side of the face to prevent the rebound hit by debris; smash long stem crops, not clenched hand to prevent hand was pull the wounded anti-crop. 7. Feeding should follow the "uniform cutting, plus a small amount of fast" principle, from less to more, until the load is normal, and maintain a continuous and uniform, to prevent "traffic jams." 8. If the entry card and block entrance and exit there, not poke with a stick and iron bars to prevent the sticks into the machine or a pop-up wounding more does not allow his hand into the entrance and exit between material, can be pushed hard stalks of raw material into the crushing chamber. 9. Pay close attention to running, and if vibration, abnormal noise, blocking or spray out material, should immediately stop checking rule, which prohibited not stop with sticks or hands, or pulled out by force feeding material to avoid damaging the arm or bash the machine . 10. Prohibited in the mill running open the door; belt drive should be set protective devices; against time overload operation; a variety of tools are not free to put materials on the mill and in order to avoid falling into the machine; workplace smoking, attention Waterproof and moisture. 11. Set flour bags made of suitable fabric and good ventilation, length of not less than 1.5m. If the set of powder bags airtight or too short may cause inlet anti-spray. 12. Shutdown preceded stop feeding, the standby arrangement of materials within the net and then shut down, the operating time after the end of dust lubrication. Second, adjust the points 1. Hopper in the lower part containing a piece of ram, or baffle, by adjusting the opening gate or baffle to control feed rate. For example, soybean processing, they should first soybean crushing, broken the maximum size should not exceed 40mtn; processing potato vines should be chopped first vine, the length should not exceed 150mm. By controlling the feed rate, can improve operational efficiency and crush quality and avoid overload. 2. General mill have two different aperture, three screen (such as tooth claw mill has aperture ø0.6nma, ø1.2mm and ø3.5mm the screen), use the screen switch to a different aperture , get a different granularity. The installation screen should be under the direction of rotation of the rotor, correct choice of mesh Connector Office of the lap to let the inside interface to swivel in the same direction, so as to avoid blocking material; if mesh conical sieve, because usually there is a small burr hole end, to facilitate the material should be installed large hole side outwards. 3. Grinder equipped with air pumps granularity in the adjustment, the adjustment can also be used to control the size of damper. I am an expert from diefeiltd.com, while we provides the quality product, such as Pvc Butterfly Valve Manufacturer , China Wafer Butterfly Valve, Wafer Butterfly Valve,and more.
Related Articles -
Pvc Butterfly Valve Manufacturer, China Wafer Butterfly Valve,
|
