|
In all normal circumstances the engine, starter or battery malfunction will cause the engine difficult to start, can not even start. In such cases, we must first understand the starter and the battery usage, so that largely determine the fault position. See more exciting information In all normal circumstances the engine, starter or battery malfunction will cause the engine difficult to start, can not even start. In such cases, we must first understand the starter and the battery usage, so that largely determine the fault position. If the battery usage time has been more than 1 year, should focus on examination of its technical condition; if the battery usage time is shorter, and start the machine a long time without maintenance, it should be played from the start the machine check. Then under the startup failures for the analysis and processing: 1, only to hear the starter starts electromagnetic switch "giggle" sound, or start the machine when you first start driving slowly turn the crankshaft a few, then there start solenoid switch "giggle" sound, but the crankshaft does not rotate. This phenomenon are generally battery "off grid" failures. 2, starts every time the temporary parking, but parking a long time or the next day start Shique can only crank about. This phenomenon is a serious self-discharge the battery, the plates, partitions serious aging, indicating that the batteries are close to retirement. 3, start the machine suddenly start turning weakness, accompanied by burning rubber smell or smoke emitting from the battery Department, mostly very pile, very poor contact and the heat burning pile clip. 4, if the start at boot-drive gear and the engine flywheel ring gear issued by the impact of the idling sound, for two reasons: First, cut into the flywheel ring gear meshing surface deformation; Second, start the machine drive gear and flywheel ring gear space too. They can not gear the engine would be unable to start. 5, Power supply Master switch a connected, start the machine drive gear and flywheel ring gear meshing with the rotation. Fault occurs, first, to maintain the starter solenoid coil connected in the wrong Power supply Posts on; second key switch on the three lines are wrong, to judge is: Key in "0" position, start the machine drive gear does not turn in the "2" position, start Motor Drive gear rotate together with the flywheel ring gear meshing. 6, startup switch to the start position engine can not start, and no Other Phenomenon. This failure, one key, switch-start circuit for wear but have not connected; Second, start the machine Relay Is not connected to starter solenoid circuit; Third, the power switch is not connected to the main circuit. 7, started with only mild "despair" bang, no any response, this is due to launch relay card. Then just click Electromagnet Tail, to force forward electromagnet can be connected to start the circuit, so that the engine starts. The e-commerce company in China offers quality products such as metal slitting cutters Manufacturer , aluminum slitting Manufacturer, and more. For more , please visit sheet metal slitter today!
Related Articles -
metal slitting cutters Manufacturer, aluminum slitting Manufacturer,
|
