|
Before braces are installed, the teeth of the patient have to be free from dental caries, gum problems and other dental issues that could pose risks during the orthodontic procedure. More often than not, wisdom teeth have to be removed depending on the situation. It is important to make sure that the teeth are healthy as you cannot move the teeth around safely if there is a serious dental condition present. Thus, the orthodontist will have the patient referred to a dentist for a thorough cleaning, filling of cavities and correcting other potential issues of the teeth. A dental mold is taken of your teeth with dental plaster before braces are installed. The orthodontist packs a tray with plaster and then tells you to sink your teeth into it. About a week later, a mold of your teeth will then be created from the imprint and now the orthodontist can track the progress of your teeth and make decisions about where to install the braces. Once the patient is cleared for orthodontics, the orthodontist will then proceed to install the braces tucson dental manufacturers created to your teeth. The teeth might be buffed first and then a small amount of special dental glue is applied to the surface. The braces are placed strategically on each tooth to make sure that it will be straightened properly. Once the braces tucson dental manufacturers created are set and dried, the orthodontist will insert a thin wire to complete them. The wire is specially chosen by the dentist to fix the specific problem of your teeth. These specialized wires come in various thicknesses and lengths. The wire of the brace is lined against the openings of the brackets and is held in place. The orthodontist snaps each of the brackets snugly in place to complete the operation. Through the entire orthodontic treatment, the wires of the braces tucson dental manufacturers are replaced and adjusted to make sure that the teeth move into place properly. The patient has to visit the orthodontist each month so that the progress of the teeth can be evaluated. Once the treatment has been completed and the braces are removed, a mold will be again created so that the orthodontist can make a retainer to maintain the position of the teeth.
Related Articles -
braces, tucson,
| 
