Packer, also known as binding machine, look likely to give some packer malfunction and troubleshooting.
Status 1: Cassette handling, when the tape stuck in the wheel center, or a foreign body can not remove the plug when the treatment is as follows:
A, open hexagonal nut washer. B, release the middle of the axis connecting the two M5 countersunk head screws, since the two screws connecting the axis of the gap in part, it is necessary to turn the screws more.
C, remove the connection axis, the turbine will be picked up, remove the jammed material.
D, according to the above c-b-a way of assembling recovery.
E, note that L type nut and maintain a 0.3-0.5mm curved plate gap
Situation Two: Automatic packer does not automatically out of band, such a case, first check out "with a length of the adjustment" is in the "0" Office, and then to see through with the process is correct, if not, get stuck with a wheel near the foreign body has cause this situation.
Three conditions: Not cut after tight bundle with a lot of things can cause this situation.
A, elastic adjustment too tight B, skid or slip film Leather belt Of oil, are located near the elastic adjustment, wipe the oil must be removed.
C, belt too tight, the seat belt cut down some, or some of the motor can be adjusted later.
D, use a thin strip or retirement with too much wheel gap.
Condition four: Adhesive ineffective. A, too hot or not, sometimes more special tape, lower viscosity and temperature can be very accurate.
B, using the voltage is not enough, there are many factories in the voltage, often inadequate, if re-using an extension cord or cable, resulting in pressure drop, to adjust the temperature changes the original low, even when the motor burned tied tight, so as far as possible avoid the use of cable lines, must use an extension cord, be thick and not take too long wires.
C, below 635 in the knife bearing torn, so there are heated and completely unable to bond.
D, electric backhoes (pendulum) on the long pull spring fatigue, so you can not blame the hand chain to locate, leading to half or less adhesive.
E, electric steel too low, or left-right, so hit on the bottom of the PP band, or left and right of the tool, but can not enter the heating should be adjusted as appropriate.
F, micro exhaust fan failure, so the temperature is too high.
Condition 5: When inserted with no action.
On the right side of LS1 Micro slide switch failure or shrapnel were foreign body blocking, but can not touch the contacts.
Condition 6: Continuously. A, LS5 failure
B, LS1 although not failure, but the contacts and shrapnel stuck between a stolen goods, or shrapnel stuck in itself, it can not be business as usual contacts with the inserted after the subsequent release. I am a professional writer from China home garden manufacturers, which contains a great deal of information about used overhead projectors , hd tv projector, welcome to visit!
Related Articles -
used overhead projectors, hd tv projector,
|
