|
|
 |
|
|
Bicycle trainer by uoiujj fewg
|
|
|
Bicycle trainer |
|
|
|
|
|
Business,Business News,Business Opportunities
|
|
A trainer consists of a frame, a clamp to hold the bicycle securely, a roller that presses up against the rear wheel, and a mechanism that provides resistance when the pedals are turned. In a wind trainer, the roller drives fan blades that create air resistance. These are typically the least expensive and noisiest trainers. Magnetic trainers have magnets that resist each other, and are moderately expensive and moderately noisy. Some magnetic trainers have handlebar-mounted control boxes to change the level of resistance during a training session. Fluid trainers use liquid-filled chambers to create resistance. They are the most expensive and quietest trainers. A small number of trainers use a centrifugal pressure mechanism to create resistance, involving pressure plates, ball bearings and specially shaped grooves. These are similar to fluid trainers in price and performance.
Trainers make it possible to build bicycle skills and power very efficiently in a highly controlled environment, without the unavoidable interruptions of outdoor riding. For instance, in hill training, instead of being limited to whatever hills are around one's home, one can simulate any size and steepness. Trainers provide better preparation for racing than stationary bicycles . Trainers require better technique than stationary bicycles, and they provide a more realistic-feeling ride. The geometry and resulting body position of a stationary bicycle may be significantly different from a racing bike; of course, if one uses the racing bike itself in an indoor trainer, the body position is nearly identical.
Members of the Timex cycling team being interviewed while working out on their trainers prior to one of the stages of the 2000 Tour of Willamette
Some trainers are equipped with sensors that monitor the rider's performance. Power output, cadence, virtual speed and heart rate are among the metrics that can be transmitted electronically. Analyzing these figures can help to fine-tune the athlete's training.
Rollers are a similar device, but they do not support the bicycle. Balancing the bicycle without flying off the rollers is an extra challenge for the rider. Some find that this helps them focus on the workout, while others prefer the stability of a trainer.
Stationary velocipede trainer, 1884
Bicycle trainers are categorized by how the unit provides resistance.
Wind the unit uses a fan powered by the cyclist's legpower to provide resistance on the rear tire. Pros: Resistance progresses with cyclist's speed, creating a realistic feeling of cycling on a road. Cons: Noise, limited resistance.
A fluid resistance trainer from CycleOps
Magnetic a magnetic flywheel creates resistance on the rear wheel. Pros: Nearly silent operation. Cons: Resistance has an upper limit, prone to breaking.
Fluid combines magnetic flywheel with fluid resistance chambers. Pros: Nearly silent magnetic operation with added progressive resistance. Cons: Repeated friction heating and consequential expansion and contraction of the fluid can result in seal leaks.
Mechanical - a belt on a modified magnetic flywheel trainer transmits motion to a heavy spinning flywheel, such as a laundry washtub. Pros: pedal powered clean clothes. Cons: Considerable do-it-yourself engineering required; imperfect design requires a strong cyclist.
Virtual Reality - this is a very comprehensive simulator, the rear wheel sits on a motorized roller and the front forks fit in a frame equipped with steering sensors, the whole system is linked to a computer with 'virtual world' software. Riders steer their way through this virtual world and pedaling gets harder (the motorized roller 'loads' the rear wheel) when going uphill. Pros: the virtual world is massive, it will hold your interest and you can fit your own bike into it. Cons: It is expensive and you do need a computer with a modern graphics card and a monitor.
Usually all trainers can be adjusted for most sizes of road and mountain bikes. However, knobby mountain bike tires can cause vibration and noise, defeating the purpose of noiseless units.
This section does not cite any references or sources.
Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. (February 2008)
A turbo trainer is any device used to convert a road bicycle to a stationary exercise bicycle, by mounting the cycle in a rigid framework. This distinguishes turbo trainers from rollers which likewise permit a bicycle to be used without moving, but which allow the cycle to sway in a similar manner to when moving on a road. Turbo trainers all provide a framework which makes the bicycle stable to sit on and pedal while stationary and some sort of mechanism to provide resistance to pedaling. More sophisticated examples provide a greater degree of control and precision to the user and a variety of feedback, particularly in modern computerized devices.
Turbo trainer resistance mechanisms
Turbo trainers apply several different physical principles to produce rolling resistance comparable to the total resistance to the motion of a cycle on the road (which is mainly due to air resistance and slope).
The simplest examples use an adjustable frictional resistance, which may be a robust band, which may be tightened by the user prior to exercise, pressing against a cylinder rotated by the back wheel of the bicycle. Other examples use a gearing mechanism to drive a large fan which takes a considerable amount of power to turn at speed, and which can be used to provide useful cooling for the user to replace the movement through air on the road. Some modern turbo trainers drive a small fan in an enclosed fluid, which provides a large and quite precise resistance to rotation in a compact device. Others use a magnetic resistance system, based on the dynamo effect. These have the advantage of allowing electrical calibration and a wide range of precise control through increasing the current passing through one of the coils.
Most turbo trainers provide a mechanism for adjusting resistance, although in the simpler devices this may only be adjusted prior to a session. However, in the large majority of designs, the resistance changes as the gears are changed on the bicycle, which allows a high degree of user control of resistance during a session.
Some modern turbo trainers incorporate a simple built-in computer which caters for a variety of user input and output. These may provide calibration of the resistance, control of resistance to emulate hills (under the control of the user or a pre-programmed schedule), measurements of mechanical power, inferred speed, pedalling cadence, heart rate (via a radio interface from a chest band) and even torque on the most sophisticated models. In addition derived statistics including integrals and averages of these statistics are commonly available. Some designs provide an interface to a standard personal computer, which allows more sophisticated processing and graphing of data.
Turbo trainers are used as a training aid by many competitive cyclists, allowing precisely controlled and monitored exercise regardless of weather and road conditions. With the wide availability of increasingly economical and sophisticated devices, turbo trainers are beginning to become a more popular exercise device for cyclists at all levels, including those who do not participate in road races. One advantage of turbo trainers over exercise bicycles is that the device itself is compact and easily stored, and a road cycle can be mounted in it for an indoor exercise session or removed for use on the road in a matter of seconds.
This section does not cite any references or sources.
Please help improve this article by adding citations to reliable sources. Unsourced material may be challenged and removed. (February 2008)
These are much more sophisticated version of the turbo trainer, once again a standard cycle is fitted into a frame and a roller is mounted very tightly against the rear wheel, when pedaling the roller turns and a series of sensors accurately record the speed and relays the information to a pc, the pc is loaded with a software program containing a virtual world (fields and villages etc.) through which the cyclist can ride, they can see themselves on the LCD monitor and they can hear the Church bells, dogs barking and cows in the meadows etc.
The faster the cyclist pedals the faster the bike moves forward, if the cyclist rides uphill in the virtual world a motor applies a load to the roller and the effect of going uphill is simulated, the rider may choose to change down a gear etc. as they prefer. The front wheel of the cycle is removed and the steering forks are mounted into a steering frame which is fitted with movement sensors enabling the cyclist to steer their way around the course. The cyclist can cycle freely around this virtual world or follow a preset course following an on-screen guide in the most popular program.
Distance, speed (mph or km/h, time and power output (kW) are shown on-screen and a heart rate monitor can be added if you wish.
Riders can log on and connect their cycles to the Internet for racing in worldwide competitions.[citation needed]
Clothes Washin' Man: A pedal powered alternative to wringing. Dave Askins, 2007 I am an expert from China Quality Dress, usually analyzes all kind of industries situation, such as pictures of american flags , tennis warm up suit.
Related Articles -
pictures of american flags, tennis warm up suit,
|
Rate This Article  |
|
|
|
|
|
Do you Agree or Disagree? Have a Comment? POST IT!
| Reader Opinions |
|
|
|
|
|
|
|
|
|
| Author Login |
|
|
 |
Advertiser Login
ADVERTISE HERE NOW!
Limited Time $60 Offer!
90 Days-1.5 Million Views
|
|
TIM FAY
After 60-plus years of living, I am just trying to pass down some of the information that I have lea...more
|
|
|
|
|
LAURA JEEVES
At LeadGenerators, we specialise in content-led Online Marketing Strategies for our clients in the t...more
|
|
|
|
|
ALEX BELSEY
I am the editor of QUAY Magazine, a B2B publication based in the South West of the UK. I am also the...more
|
|
|
|
|
STEPHEN BYE
Stephen Bye is a fiction writer. His most recent novels are a 5-book “The Developer” series which be...more
|
|
|
|
|
PAUL PHILIPS
For more articles, blog messages & videos and a free e-book download go to www.NewParadigm.ws your p...more
|
|
|
|
|
LEVAL AINAH
I am an internet marketer and also an educator. My goal is to help others who are looking to improve...more
|
|
|
|
|
GENE MYERS
Author of four books and two screenplays; frequent magazine contributor. I have four other books "in...more
|
|
|
|
|
ADRIAN JOELE
I have been involved in nutrition and weight management for over 12 years and I like to share my kn...more
|
|
|
|
|
MICHAEL BRESCIANI
Rev Bresciani is the author of two Christian books. One book is an important and concisely written b...more
|
|
|
|
