|
The Abrasive-blast-cleaning action is obtained by the forceful impingement of abrasive particles accelerated towards the workpieces by different methods, like air blasting or power driven rotating bladed wheels. Wet blasting uses finer abrasive particles in a pumped slurry delivered through nozzles to impinge upon the parts. It is considered for delicate parts and for lighter processing. Abrasive-blast-cleaning particles can be selected from a range of materials depending on the workpiece material, the contaminants to be removed, and the purpose of the cleaning action obtained. Particles may be hard, like crushed hardened cast steel, or soft like crushed walnut shells or of intermediate hardness. Among the materials more frequently used one can find silica sand, naturally occurring garnet, dolomite, flint quartz or manufactured compounds like aluminum oxide and silicon carbide. The size of the particles to be used in any specific job is standardized according to the weight percentage passing through or remaining on sieves of given mesh (screen opening). With continued blast cleaning machines , the particles become dull and dirty, picking up some of the soil they remove and their size decreases to fines. Therefore for process quality control, one has to remove periodically part of the used material, discarded as useless, and replenish the equipment storage with new and clean grit or sand as applicable. Equipment exists of various shapes and design: as cabinet type machines or as enclosed tunnels accepting a continuous flow of parts presented on a conveyor. Small parts are introduced in the working space and then the door is closed. Operators use gloves attached to the cabinet wall to move around the parts and to direct the nozzles. Workers must be protected from inhaling air mixed with fine silica. In the working space air must be controlled and suitable ventilation must be established. Workers' health is protected by controlling the level of air contamination they breathe, and by submitting them to periodic x-ray inspection with physician control. For very large parts special equipment is available that directs the blast to the workpieces, placed in the open, from a short distance. The excess abrasive is immediately sucked back in an external concentric conduit. Operators must wear special protective clothing and accessories, and must breathe through suitable masks providing filtered air. Processing time depends on workpiece materials, type and degree of soil to be removed, shot or sand type and size, and power or performance of equipment. It must be determined by actual experiment and test. One should not use a single sandblasting machines material for all kinds of workpieces. To avoid unacceptable contamination one should avoid processing in the same machine workpieces of different metals, without thorough equipment cleaning and changing completely the charge of the abrasive. For certain delicate part preparations like thermal spray it is good practice to dedicate separate machines to different jobs to avoid surface degradation.
Related Articles -
blast cleaning machines, sandblasting machines,
| 
