|
Hongxing impact crusher manufacturer has been committed to the technology innovation of jaw crusher for many years by adhering to “science and technology are the primary productive forces”. At present, compared with the other crusher, our latest impact crusher has significantly improved in the stability, durability and energy saving.
Hongxing impact crusher advantages:
1, large crushing ratio; the crushing ration of general crusher is less than 10. However, the crushing ratio of impact crusher is usually 30-40; the maximum can be up to 150.
2, high efficiency and low power consumption.
3, uniform particle size and less over milled phenomenon;
4, selective crushing; in the crushing process, the useful minerals and gangue can be crushed along the joint surface, which is helpful to monomer separation and has significantly effect on the coarse-grained minerals.
5, strong adaptability;
No matter how we improve the impact crusher from the raw material to motor power, the new impact crusher and old type machine will not change the working principle. The impact crusher is a crushing machine which uses impact energy to crush the materials. This is the definition og impact crusher in the machinery industry. Any out of this definition machine cannot be called as impact crusher.
Driven by the motor of the impact crusher, the rotor revolves at a high speed. Then the materials will be thrown to the impact plates for crushing. The materials in the impact crusher will be shot back to the blow bars again. This process repeats until the materials are crushed to the required size and discharged through the discharging opening at the bottom of the machine. Adjusting the gap between the impact rack and rotor support of the impact crusher, the size and shape of the end products can be changed.
The main working part of hammer crusher is rotors with hammer. The rotors consist of main shaft, disk, pin shaft and hammers. The motor drives the rotors to rotate quickly in the crushing cavity. Raw materials enter the crusher through the feed opening and are stricken, impacted, cut and ground by the high-speed hammer to small size.
There is a screening plate under the rotor, so that materials with size smaller than the screen mesh will be screened out and others are left to be further hammered and ground until reach the standard size. The size of the final product can be adjusted by changing the screening plate. The gap between the rotors and the screening plate can also be adjusted. sand washing plant : http://www.hxjq-crushers.com/8.htm
Cone crusher manufacturer : http://www.hxjqcrusher.com/Cone-crusher.html
Related Articles -
culture,
|
