|
Removal charges can be as expensive as installation fees, so by removing the old carpet yourself you can easily save hundreds of dollars or more. While it's advisable to get professionals to install new carpet, or even new hardwood floors, it can save a lot of money to remove the old carpet and padding yourself. Follow the tips below and you'll be on your way to saving money and getting the finished product you want! If your carpet needs an update or it's just time for a change, why not save money on removal charges by doing it yourself? Replacing old carpet with a new floor covering is one of the most expensive changes homeowners can make. The materials alone are costly; plus there are installation, furniture moving, old carpet removal and disposal charges. Here are some helpful steps to take when removing old carpet. Allow enough time. The more you rush a DIY project, the more damage you are likely to cause, both upon your house and yourself. Make a plan. It is best to know where you are temporarily storing the furniture and personal belongings from the room ahead of time, rather than randomly placing belongings in every nook and cranny of the house. Be sure to measure larger furniture like couches and entertainment units beforehand. It will save you a lot of struggle and distress. Protect yourself. Carpet may seem soft when you walk on it, but underneath you will find tack strips and staples, as well as rough edges. Dress accordingly with work gloves, proper footwear and kneepads. Check the baseboards. If the baseboards were installed after the carpet, they will probably have to be removed before pulling up the carpet. You can either re-use existing baseboards, or add trim mould for an upgraded look. Cut the carpet. Using a strong blade, start by cutting along the short side of the room—about three feet from the edge. Be careful not to damage the floor underneath when cutting. It's easiest to cut the carpet into manageable strips. Pull up the carpet. Start by grabbing the first strip of carpet near the newly cut edge, rather than sticking your fingers where the tack strips are. The carpet should pull up fairly easily and can be rolled up for removal. Take out the padding. Usually the padding beneath the carpet will be stapled into place. You can use a knife or scissors to remove padding in the same manner as pulling up the carpet. Remove the staples. Using a screwdriver, pry the staples out from the floor. You can then pull it out with a pair of pliers if necessary. You should aim to have the smoothest surface possible for the new carpet. Confirm with your carpet installer, but usually you can leave the tack strips in place if they are in sufficient condition for re-use. For further assistance with your carpet needs, call the professionals Auckland Carpet Steam 'N Dry to do effective job for you
Related Articles -
Carpet repair, carpet repairs, carpet repair Auckland city, carpet repair west Auckland, carpet repair east Auckland, carpet repair northshore, carpet,
| 
