|
Glass can also be fitted with a defrosting circuit or antenna. Self-defrosting glass has a conducting grid or invisible layer that carries electric current to heat the glass. A grid type is common in rear windows. Windshields use a transparent conducting medium. A window antenna wires for radio reception is placed either between the layers of laminated glass (windshield) or printed on the surface of the glass (rear window). Some glass has antenna wires and heating wires side by side. Anti-lacerative glass has one or more additional layers of plastic affixed to the inside of the glass. This glass gives added protection against shattering and cuts during impact. Modular or encapsulated glass has a plastic trim molding attached to its edge. It also fits the contours of a vehicle more closely than glass used in the past. Modular glass is the newest glass used in unit body applications. wichita auto glass replacement involves two different methods: gasket installation or adhesive installation. The adhesive installation is further divided into two methods: the full cutout and the partial cutout method. Windshield gasket is a rubber molding shaped to fit the windshield, body, and trim. The gasket installation method is common in older vehicles but still finds use in present day vehicles. The gasket is grooved to accept the glass, a sheet metal flange, and sometimes the exterior reveal molding. The gasket locking strip must be removed before the glass can be removed from the opening. A windshield gasket is a rubber molding shaped to fit the windshield, body, and trim. The gasket installation method is common in older vehicles but still finds use in present day vehicles. The gasket is grooved to accept the glass, a sheet metal flange, and sometimes the exterior reveal molding. The gasket locking strip must be removed before the glass can be removed from the opening. The adhesive installation, as the name implies, uses an adhesive material to secure the glass in place. The use of adhesives permits the wind-shield to be mounted flush with the roof panel, decreasing wind drag and noise. Rubber stops and spacers separate the glass from the metal. Reveal molding is metal or plastic trim that fits around the vehicle's glass to cover the gap between the body and any glass adhesive. Depending upon the molding design, it can be held in place with small clips, adhesive, or a friction fit. The partial cutout method of windshield replacement uses some of the original adhesive. The old adhesive must be in good condition and of sufficient thickness. It serves as a base for the new adhesive. When the original adhesive is defective or requires complete removal, the full cutout method of Wichita auto glass replacement is used. Author Resource: The Author Rozer Fedral is conveying information about auto glass wichita
Related Articles -
wichita auto glass replacement, auto glass wichita,
|
