Carpets, rugs and upholstered furniture are especially vulnerable to infestation.When fleas infest your home, they can get everywhere; in fact, any place your dog or cat frequents, fleas will be present.Vacuuming and steam cleaning carpets and rugs will help, but there are natural treatments that can be even more effective. One of these treatments is safe and uses a common everyday substance – salt. Yes, you can get rid of fleas with salt! The salt acts as a dehydration agent and dries out the bodies of the fleas. How to kill fleas using salt: Obtain some highly refined household salt or sea salt. Make sure it is as finely ground as possible, almost to a powder consistency. Sprinkle it lightly but evenly over your carpet. Brush or rake it in. Leave this in your carpet for 12 to 48 hours, then vacuum thoroughly. For serious infestations, salt can be mixed together with boric acid. This chemical is found in a number of commercially-available products, such as Borax. Use the same technique as with refined salt; however, check with the carpet manufacturer to make sure your carpet can withstand boric acid. While boric acid is generally non-toxic, long-term, low-level exposure to boric acid can cause some health conditions in humans and pets, so this treatment should not be used frequently. Steam Cleaning It is possible to use steam cleaning to kill these awful little critters, and you can actually do so with little problems and a very simple and effective step-by-step solution.As you begin to steam clean your intended space (after vacuuming and reading the safety instructions inherent with the particular brand of steam cleaner you are using), make sure that you start at the top of the room with your drapes, curtains, and other areas, and work down to the bottom. The steamer can be used on most any surface, but it’s best to start from the top of the room and work your way down – as well as making a point to never steam into an electrical outlet, or near electrical appliances! As always, too, take your time with the steam cleaner. Make sure you are moving no more than about 1 inch of space per second, with the steam cleaner a mere two inches from the surface you are cleaning; this allows you to really take your time and get the most out of your steam cleaning capabilities from here on as you move forward to kill bed bugs, dust mites, and other critters. After you are done, allow your steam cleaning surfaces to dry for several hours before use, but you can rest assured at night that if you’ve done it right and well, you can adequately get the job done with a steam cleaner! Check out more from professionals Auckland Flea Control for reliable assistance
Related Articles -
Flea control, flea controller, flea controllers, flea control Auckland, flea control northshore, flea control west Auckland, flea controls Auckland,
|