Shanghai Zenith is a professional ball mill supplier, and it produces various ball mill products and analyzes the used ball mill problems for its customer. Shanghai Zenith is not only a ball mill supplier in China, but also the solution scheme. After the ball mill operates for some time, there is some spray orifice on the spray bar which is blocked by the impurities in the oil, at this time, the oil pressure in the spray orifice rises which leads to the other orifices unplugged increase in flow chart. The oil near the oil slinger will splash out of the oil slinger which leads to the oil leakage. Solutions: dredge the blocked oil hole on the spray bar, and check the ball mill spray bar regularly and clean in time once the banked-up spearhead is found. Pay attention to that the clean the oil sprout hole by the soft texture tool to avoid the hardness material’s damage to the oil sprout hole. There is another reason for the ball mill oil leakage, that is when the opening of the ball mill front (rear) tile accelerator is relatively large, the oil sprout quantity will be increased. So the oil will drop from the orifice to the hollow shaft and then splash out of the oil slinger and leak out from the felt oil seal. And the ball mill solution is that turning down the accelerator properly to decrease the sprout oil mass. When adjust the accelerator, it should be done by the experienced people. As in case the accelerator is turned down undersize, the lubricant oil quantity of the bearing will be insufficient and the friction force will be increased which makes the main bearing set temperature rises. Once the phenomenon can’t be dealt with, the main bearing will be burnt up. As a ball mill and jaw crusher supplier in China, Shanghai Zenith is trustworthy and has gained good word of mouth. All the ball mill customers can be assured of the ball mill products quality. Look forward to cooperate with you.
Related Articles -
Ball, Mill,
|