|
Using the D-or V- Turning tool The time for turning films, blade movement is a problem, often used for profiling long-turning blade milling run, in particular. It affects most of the blades, and precision machining is obvious. Center clamping screw and the distance between the cutting edge longer the blade base anchor may occur the greater the pressure the plastic deformation, so that cutting edge is moved. In turning, the formation of a single blade surface, the surface finish and tolerance from the limits, therefore, offset blade will directly affect part quality. Blade in the base shift, even if only slight movement, can also cause deterioration in chip formation and tool wear. When the problem was found when the moving blade, cutting parameters are usually reduced to eliminate the blade on the part of the force, resulting in significantly lower production efficiency. When the cutting depth can start from a relatively small level of finishing is reduced, relative to the depth of the blade is small in terms of nose radius, so that deterioration of chip fracture, cutting enough. Lock blade clearly eliminates the need to reduce the cutting parameters. Cutting edge micro-Mobile is not a new phenomenon occurs, but the concept of indexable inserts the inherent problems. But until recently, the problem Caibei increasingly widely considered to be fine turning or turning in all kinds of semi-refined source of the problem. Over the years, clamp design has been improved and now have quite a lot of sound and effective solutions put into use, these have improved stability of blade positioning. The challenge now is to prevent the movement of tiny blade, or even to reconsider the method of turning cutter blade clamping. Sandvik Coromant is now pioneering a kind of a solution to eliminate root causes. CoroTurnTR turning blade system with excellent mechanical structure based on a combination of improved technology and manufacturing methods, it was first introduced to the most vulnerable of the D-and V-blade, mainly used for medium machining to finish the profile milling operation . TR is a T-bar solutions for the fixed blade in Chuck The position. When the cutting force acting on the cutting edge, the vertical and horizontal precision rod to prevent the blade in the base is moved. CoroTurnTR accurately place the blade on top of T-bar, in order to offset skewed cutting edge to the blade clamping device and the distance between the blade and the cutting force imposed to minimize the leverage effect. Blade cutting edge is not as fixed in the location from its original deflection, it can consistently maintain a very tight tolerances. Initial operation showed the way with the use of conventional blade clamping compared to the longer blade life, more predictable. Clearly, the results of the early beneficiaries of this development is a bulk manufacturer of precision parts. However, turning through the use of a flexible tool to provide consistent dimensional accuracy and surface finish accuracy, completed in a single clamping components on a one-time multi-task machining machine tools can also benefit. Due to a higher parameters in cutting process, while reducing blade translocation and reset the interrupt number, the production efficiency can be improved. The e-commerce company in China offers quality products such as clock alarm clock , window lock, and more. For more , please visit Quality Manufacturers today!
Related Articles -
clock alarm clock, window lock,
|
