Feed grinders, main portion of the feed machine, have wonderful importance in agricultural creation. There are different types of feed grinders, and now I'll give a quick introduction to these devices and their usages. Oppositely rolling roller crusher is a grinder using two cylinder grinding rollers which are running in relative rotation for cutting and grinding the feeds. These grinders are mostly applied in the mill industry of wheat. And the feed mill industry tends to use them for the very first working procedure of secondary crusher. Flat-hammer mill is one kind of grinder applying hammers running at high speed for shattering the feeds. Gear claw disintegrator, using hocks rotating at high speed to crush the feed, enjoys the positive factors like small volume, light weight, fine particle size and high rotating speed. In picking the feed grinders, you need to first confirm the item model based on the number with the project items. And then you can choose the specific product in line with the quality, price and the supply of components. Finally you need to check the appearance, accessories, manuals and certifications. The feed grinders need to be fixed on the cement foundation if you need to use it for a long term. And if you change their working place frequently, you need to fix the grinders and the motor on the engine base made of angle iron. If the grinder is powered by diesel, the power of the two should be in match with one another. That is to say, the power in the diesel engine needs to be slightly higher than that with the grinder. What's more, their grooved pulleys from the belt need to be in line and the exterior end faces in the pulleys need to be located in the same plane. Check every fastener after finishing installation in the feed grinder and if find any loose component, fasten it tightly. And then check the degree of tightness and whether the motor reel is in the same plane with the crusher shaft. Before starting the feed grinder, check the hock, hammer plate and rotor by rotating the rotor by hand. And check whether the rotor turns in the same direction with the arrow on the machine and whether the motor and the grinder are well lubricated. You'd better not change the pulley frequently in order to steer clear of explosion of grinding room due to the machine's very high rotating speed. Put the feeds in the grinder after it idles 2 to 3 minutes without any breakdown. Pay excellent attention to the grinder's operating situation and put the feed evenly in order to avoid the blocking with the stuffy car. And make sure that the grinders do not work overtime or in overloaded condition. If find you'll find vibrations, noises, high temperature from the bearings and the grinder, and some feeds sprayed outside, you need to stop the feed grinder and start work only after all the troubles are cleared.
Related Articles -
feed mill, feed machine,
|