|
Cleaning operations using abrasive blasting can present risks for workers’ health and safety, specifically in portable air blasting or blast room (booth) applications. Although many abrasives used in blasting rooms are not hazardous in themselves, (steel shot and grit, cast iron, aluminum oxide, garnet, plastic abrasive and glass bead), other abrasives (silica sand, copper slag, nickel slag, and staurolite) have varying degrees of hazard (typically free silica or heavy metals). However, in all cases their use can present serious danger to operators, such as burns due to projections (with skin or eye lesions), falls due to walking on round shots scattered on the ground, exposure to hazardous dusts, heat exhaustion, creation of an explosive atmosphere, and exposure to excessive noise. Blasting rooms and portable blaster’s equipment have been adapted to these dangers. OSHA (Occupational Safety and Health Administration) mandates engineered solutions to potential hazards, however silica sand continues to be allowed even though most commonly used blast helmets are not sufficiently effective at protecting the blast operator if ambient levels of dust exceed allowable limits. (Respiratory protection is approved by NIOSH – National Institute for Occupational Safety and Health). Typical safety equipment for operators include 1.Positive pressure blast hood or helmet – The hood or helmet includes a head suspension system to allow the device to move with the operator’s head, a view window with replaceable lens or lens protection and an air feed hose. 2. Grade D air supply (or self contained oil-less air pump) – The air feed hose is typically attached to a grade D pressurized air supply. Grade D air is mandated by OSHA to protect the worker from hazardous gases. It includes a pressure regulator, air filtration and a carbon monoxide monitor/alarm. An alternative method is a self contained oil-less air pump to feed pressurized air to the blast hood/helmet. An oil-less air pump does not require an air filter or carbon monoxide monitor/alarm, because the pressurized air is coming from a source that cannot generate carbon monoxide. As the professional manufacturer of complete sets of mining machinery, such as stone crushing plant, Henan Hongxing is always doing the best in products and service. dryer machine:http://www.hxjq-crusher.com/21.html
ball mill:http://www.hxjq-crusher.com/20.html 3. Ear protection – ear muffs or ear plugs. 4. Body protection – Body protection varies by application but usually consists of gloves and overalls or a leather coat and chaps. Professionals would wear a cordura/canvas blast suit (unless blasting with steel abrasives, then they would use a leather suit). In the past, when sandblasting was performed as an open-air job, the worker was exposed to risk of injury from the flying material and lung damage from inhaling the dust. The silica dust produced in the sandblasting process would cause silicosis after sustained inhalation of the dust. In 1918, the first sandblasting enclosure was built, which protected the worker with a viewing screen, revolved around the workpiece, and used an exhaust fan to draw dust away from the worker’s face. Several countries and territories now regulate sandblasting such that it may only be performed in a controlled environment using ventilation, protective clothing and breathing air supply. Worn look jeans Many consumers are willing to pay extra for jeans that have the appearance of being used. To give the fabrics the right worn look sandblasting is used. Sandblasting has the risk of causing silicosis to the workers, and in Turkey, more than 5,000 workers in the textile industry have been stricken with this disease, and 46 people are known to have died due to this. Sweden’s Fair Trade Center conducted a survey among 17 textile companies that showed very few were aware of the dangers caused by sandblasting jeans manually. Several companies said they would abolish this technique from their own production.
Related Articles -
mining,
| 
