|
I have worked in residential and commercial companies for 23 years, and I would like to help you beguile some pitfalls in floor preparation. The most useful factors to regard in flooring preparation are moisture considerations, proper support in the subfloor, inconsistencies in the subfloor, and severely tilting floor applications. At the beginning of a project it is important to inspect the moisture levels of the air in the room, the moisture of the flooring to be installed, and the moisture of the subfloor in the installation area. I would suggest keeping the flooring planks in the flat where it is going to be set up for a bare minimum of 1 week prior to installation, but better for a month to properly calibrate the three moisture issues mentioned. In addition, be careful to ensure that the moisture barrier between the subfloor and the installation flooring is sufficient so that the subfloor doesn't manipulate the flooring during various periods of the weather. I would recommend that you walk over all areas of the flooring of the floor to determine how resilient the floor is. Does the subfloor have movement when you walk over it? Does the flooring vibrate, squeak when you walk on it? It is important to screw down any detached hideaways of the subfloor. Also, if you are going to install your subflooring in the same direction as the flooring joists you should in most instances lay out extra joist support beneath the subfloor. If the subfloor has any flux or is badly supported the end result could be a flooring project that will not last or become demolished due to lack of discretion. When a flooring job has imperfections in the flooring surface they can be dealt with in a variety of ways. If the inconsistencies aren't too harsh you can fill holes or gaps in the surface of the subfloor with filler substances designed for this intent. If the amount or problems in the subfloor are more crucial it might be best to install a layer of nice smooth faced plywood over the whole subfloor surface. On many of my own jobs this was the best way to handle imperfections and drastic resiliency problems. The way the damaged subfloor was installed and the direction of your flooring joist will determine the best direction to run the layer of subfloor. In the most all-important situations when the subfloor is rotted or badly shattered it might be necessary to tear out the existing subfloor and reinstall the subfloor. But this type of correction is needed in only the worst of situations. One of the final types of scenarios that arise on some jobs is inadequately tilting subfloor. This type of difficulty could be easily take up several volumes on its own, but I will only concisely touch on the solutions here. I would recommend you have an accomplished expert look at your particular problem. But if the problem is bad you might have to support the subfloor and lay new or additional supporting posts for the flooring. In minor situations where the slope is slight you might be able to just trowel leveling compound to correct the situation. In ending, I would urge you to take the time to look at these situations on your own work situation so that your flooring can last for generations to come and be admired by your friends and family. If you would like more installation articles related to flooring, tool reviews of pneumatic floor nailers, or information on floor nailer pneumatic sytems please click here to visit my site.
Related Articles -
porter cable floor nailer, porter cable fcn200, pnematic floor naler, floor nailer pneumatic, floor nailer, hardwood floor nailer, cleat nailer, wood,
| 
